John the Ripper installieren

John the Ripper is usually pre-installed in Kali Linux but if you don’t have it yet, you can follow the steps below to install it on a Linux-based machine. 

 If you are facing any challenges with Kali Linux, I suggest you go through  getting started with Kali Linux  article. 

 There are numerous ways of installing John the Ripper on your machine but we will look at some of the basic ones: 

 1. Installing from the source 

 Open the terminal by simultaneously holding  Ctrl+Alt+T  and run the command below. 

 mkdir src

 

 This creates a directory where we’ll store all our files. 

 Navigate to the  src  directory and clone John the Ripper repository as shown below. 

 cd src

git clone https://github.com/openwall/john.git

 

 

 This creates a directory named  John . To make it active, we need to run the command below. 

 cd john

 

 Navigate to the  src  directory where we’ll set and configure the compilation sources. 

 cd src

./configure

 

 

 Run the  make  command to compile source code into executable programs and libraries. This might take some time depending on your machine and the resources allocated to it. 

 make

 

 Lastly, run the  make install  command to install John the Ripper. 

 make install

 

 

 Run the commands below to see if the installation was successful. 

 cd ..

cd run

./john 

 

 

 

 

 Version #1 Erstellt: 19 October 2022 11:16:51 von hermann Zuletzt aktualisiert: 19 October 2022 11:17:17 von hermann